Gallery

Table saw extension

By benmess, member Feb 09, 2010

I made this extension for my Delta TS200. Made out of 3/4″ MDF and 1/2″ plywood with front and back steel rails.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

See all newsletters

Get It All!

UNLIMITED Membership is like taking a master class in woodworking for less than $10 a month.

Comments

USMCDENNIS | Feb 11, 2010 01:11am | #1
Nice extension to have. I'm sure its very useful. Enjoy!
dogwood51 | Apr 08, 2010 10:33am | #2
hi that really nice its what im looking for do you have the plans and some info on how i can make one Thanks
smoloney | Apr 21, 2010 04:34pm | #3
is the extention fence your own design? what did you use?
jimswoodproducts | Oct 05, 2010 03:57pm | #4
Very nice design, l was planing to make a simulr one to put my router into think could be used for both, any suggestions?
How did you secure the metal support on extension, if they fold down to the sides when not neededl was thinking of making one on each end and make on back as a outfeed table.
jim

Log in or create an account to post a comment.

Up Next

Featured Workshop

Queen Anne Side Chair with Dan Faia

With its graceful curves, cabriole legs, and ornamental back splat, a Queen Anne side chair is a bucket list build for many woodworkers. Dan Faia had a very specific Queen…