The Thin Air Press opens the door to vacuum veneering for the woodworker who can’t afford the relatively high cost of a conventional compressor-driven vacuum press. This simple system, made by the Roarockit Skateboard Co., uses a vinyl bag with a one-way valve and a hand pump to draw a vacuum.  I used the press to veneer both flat and curved parts and was impressed with its simplicity and performance. I tried both the 13 1/2-in. by 47-in. and the optional 26-in. by 28-in. bags.  The company claims that the pump will pull about 15 psi. I found that the vacuum held overnight, more than enough time for most glues to set.  For more information, visit the manufacturer’s Web site: www.roarockit.com.

—Anatole Burkin is the editor.

Fine Woodworking Recommended Products

Stanley Powerlock 16-ft. tape measure

With its smooth lock, tough case, compact size, and excellent accuracy, this Stanley tape is perfect for workshop use.

Buy at Amazon

Dividers

Incredibly useful for laying out, setting equal distances, and comparing measurements, these are an essential tool for any furniture maker.

Buy at Amazon

Jorgensen 6 inch Bar Clamp Set, 4 Pack

Small light-duty clamps are best bought in quantity. These clamps are a great balance of affordability and quality—so stock up!

Buy at Amazon