As anyone in the market for a combination blade, also called a general-purpose blade, knows, there’s no shortage of choices, even in the upper price range. Curious to know whether any of these blue bloods stood out, I decided to test 14 top-of-the-line 10-in. combination saw blades for smoothness of cut.

With each new blade, I ripped and crosscut a 3/4-in.-thick maple board to produce a 2-in.-square sample. After that, the ripped and crosscut edges on each sample were checked for smoothness on a high-tech machine called a surface and roughness profiling system, which can measure very small surface deviations. Then, based on the machine measurements, the smoothness of each rip and crosscut was rated as excellent, very good, good, or fair.

The CMT scored a good in both the rip cut and the crosscut.

Fine Woodworking Recommended Products

Ridgid EB4424 Oscillating Spindle/Belt Sander

With five spindles sized from 1/2 in. to 2 in. and a 4 X 24-in. belt, this sander has become a staple in many a shop Fine Woodworking visits.

Buy at Amazon

Ridgid R4331 Planer

Priced nearly $300 less than the DeWalt 735X, the Ridgid R4331 is an excellent value. Its three-knife cutterhead left wonderfully clean surfaces on plainsawn white oak and white pine. It did not perform nearly as well on curly maple as the 735X.

Buy at Amazon

Freud Super Dado Saw Blade Set 8" x 5/8" Bore

Leaves a dado with a flat bottom and even performs excellent on plywood and melamine.

Buy at Woodcraft