The most common problems caused by moisture in wood are finishes that don’t stick, joinery that breaks apart, and boards that take on new and unwanted shapes after milling. The solution to all these problems is to use wood that has been dried to the right moisture content, between 8% and 12%. And the easiest way to determine moisture content is to use a moisture meter.

Moisture meters use either pins or an electromagnetic plate (pinless) to measure moisture. Some pin-style meters take deep readings with hammer probes; others take readings from 5/8 in. or less. Both styles leave marks. Pinless meters leave no marks but require the wood surface to be smooth; they detect moisture down to about 5/8 in. I looked at a dozen meters priced from $60 to $350 and was surprised to find that their overall accuracy is quite good.

The Protimeter Digital-Mini is a functional meter with very accurate calibration and sturdy construction. It offers a digital readout and comes with a good case and a belt loop. The species correction is detailed, with many options. There are, for example, six options for oak.

Fine Woodworking Recommended Products

Jorgensen 6 inch Bar Clamp Set, 4 Pack

Small light-duty clamps are best bought in quantity. These clamps are a great balance of affordability and quality—so stock up!

Buy at Amazon

Double Sided Tape

A thin woven core makes XFasten tape strong yet not too thick (0.008 in.), and helps it hold powerfully without being difficult to peel off.

Buy at Amazon

Veritas Micro-Adjust Wheel Marking Gauge

The adjuster runs through the beam from a small knob at the back end right to the cutting wheel, which moves in and out as you turn the knob. This arrangement works well but makes adjustments a two-handed operation, requiring a little more effort.

Buy at Lee Valley