I’m a big advocate of working at the proper height for specific tasks. So I was intrigued by the concept of the Noden Adjust-a Bench, a workbench system that can be adjusted to a variety of heights.

The Adjust-a Bench is available as either a set of adjustable legs (you’ll have to supply the top and vises) for $430 or as a complete bench, which includes the legs, a wood stretcher, and a top, for $800. We added a few accessories–benchdog holes ($50) in the top, Jorgensen vises ($300), and locking casters ($160). Initial assembly was straightforward and relatively easy.

The ratcheting adjustment mechanism lifts the benchtop in 1-1/2-in. increments from roughly 28 in. to 45 in. high. This adjustable height feature proved very useful for tasks ranging from assembly work to planing to close detail work. Noden suggests using the bench as an outfeed table, but setting it to the correct height could be a very fussy operation because of the 1-1/2-in. increments.

With the legs on the floor, the bench was rigid enough for planing tasks, even at its maximum height. Not surprisingly, though, when fitted with the casters, the bench moved quite a bit.

The top supplied by the manufacturer is essentially a 1-3/4-in.-thick wooden kitchen countertop, which worked well enough. It is available in three sizes: 24 in. wide to 30 in. wide and 60 in. long to 72 in. long. The one we purchased was not perfectly flat, but it was within 1/16 in., an acceptable tolerance. The Jorgensen quick-release vises are mounted on the side and end of the bench (not flush with the edge, but sticking out). They are good-quality heavy-duty vises, although small for my taste.

The adjustability of this system makes it a versatile addition to a shop. If I were buying it, I’d be inclined to purchase the base system (legs only) and add a better top and larger vises. For more information about pricing, go to www.adjustabench.com.

Photo: Matthew Berger

Fine Woodworking Recommended Products

Rockler Deluxe Panel Clamp

These clamps can handle glue-ups between 10 in. and 36 in. wide, and boards up to 3 in. thick. Sliding feet attach to the lower bars with magnets, letting you position them quickly for stability on any surface. The spring-loaded jaws adjust easily, dropping into notches along the bars. And the powerful clamp handles clear the benchtop.

Buy at Amazon

Veritas Wheel Marking Gauge

A wheel-type gauge is the easiest to use, and this wonderful Veritas model is a steal at $38.

Buy at Lee Valley

Bessey EKH Trigger Clamps

Bessey EKH series quick-release trigger-style clamps are simple to use and maintain consistent pressure. Trigger clamps that perform the way you've always wished they would!

Buy at Amazon