It always feels awkward to carry the multiple parts of my dado set from a nail on the wall over to the saw, plunking them down on the cast iron. I worry about dropping a cutter on my toe or damaging a carbide tooth.
This dado-blade caddy solves the problem. I made it from scrap plywood, using two dadoes, four screws, a couple of dowels, and glue. It is light, strong, and balances nicely. Pick it up by the handles and the components stay put. Set it down and they are easy to access.
Jeffrey Kusama-Hinte, Brooklyn, NY
Fine Woodworking Recommended Products
Rockler Dust Right 650 CFM
While all five of the smaller units will collect chips efficiently when deployed properly, the 3/4-hp Rockler was just a bit more powerful in our suction test.
Shop Fox W1826
The thick, felted bag on this Shop Fox is a plus and a minus. On one hand, it makes the unit much less expensive than collectors with canister filters, and also lighter and easier to hang on the wall. Without a separate plastic bag to catch chips, however, they stay in the felt bag, and the shortish zipper on the bottom makes it tough to shake them out. Otherwise, the W1826 is an excellent value.
Ridgid R4331 Planer
Priced nearly $300 less than the DeWalt 735X, the Ridgid R4331 is an excellent value. Its three-knife cutterhead left wonderfully clean surfaces on plainsawn white oak and white pine. It did not perform nearly as well on curly maple as the 735X.
Log in or create an account to post a comment.
Sign up Log in