Comments

1. 
   Richard305 | Sep 04, 2018 09:55pm | #1

   Excellent video. Worth taking the time to watch!

2. 
   Formidable | Sep 06, 2018 08:14am | #2

   I try my best to ONLY use a router table. I find using free routers (both full-sized and trim routers) to be like trying to guide a ravenous flesh-eating gyroscope. A large (usually shop-made) base with good handles and plenty of bearing surface is a must. Even then, I only break out the router when I can't reasonably find a different method for a task. And that's rare.

3. 
   user-6524153 | Sep 09, 2018 09:55pm | #3

   What router lift is being used in the table?

4. 
   user-5718416 | Oct 30, 2018 09:33am | #4

   Love the video, thank you!

   I'm about to build a table and would love a couple pointers:
   - Do you insert shelf boards in the cabinet to aid dust collection? I see the supports.
   - Can you give a link to that amazing router lift?

   -Thanks!

5. 
   16Laramie | Jan 02, 2019 11:12am | #5

   Terrific set of videos! I already do a fair amount with my router table, but I learned some great tricks here. Thanks.

6. 
   srmmmm | May 29, 2019 09:30am | #6

   I agree 100% with Bob's recommendation to avoid climb cuts. The only time I've experienced a power tool related injury in 20 years was performing a light climb cut on some curly maple. The 12" long work piece shot off the table putting a hole in the sheet rock on the wall, and allowing my left thumb to graze the spinning bit before I could fully react and step back from the table. Never again!

7. 
   ShopMan75 | Oct 18, 2019 03:10pm | #7

   I fully agree with Bob's comments on keeping the fence system simple. I have/had a WoodPecker Super Fence and it drove me absolutely nuts. I could not get the two fence halves co-planer no matter what I tried. I milled up a solid piece of of ash and used the two clamps as shown in the video. It works great. The Super Fence is on Craig's list.

8. 
   hot_lead | Jun 17, 2020 04:58pm | #8

   Thanks Bob, Great Class, best 90 minutes I've spent in a while.

9. 
   JWCollier | Jan 23, 2021 10:34am | #9

   I’m on a Transatlantic flight with streaming internet on the plane, so I’m doing a Van Dyke-fest. I love Bob’s style, no BS. If you’re expecting safe-space therapy with your woodworking, don’t watch Bob Van Dyke.

10. 
    mitch912 | Aug 02, 2023 08:03pm | #10

    Good video, but...........if the captions were over in the corner rather than in the middle, the subject of discussion would be visible.

1. 
   benstrano | Aug 03, 2023 08:27am | #12

   You can turn the captions off if you like.

1. 
   user-6181340 | Jul 24, 2024 03:48pm | #13

   How?

1. 
   daverichards | Jul 24, 2024 05:51pm | #14

   Click on the Closed Caption button and then select captions off

   
11. 
    turnertoo | Aug 03, 2023 07:48am | #11

    Thank you Bob, mis your classes and demos at the Northeastern Woodworkers Association now in Albany.