I’m a big fan of little power feeders. They can turn a router table into a small shaper, take the tedium out of ripping stock on the tablesaw, and allow a bandsaw to resaw without all the irregularities of feeding by hand. They also provide a big safety margin. The Little Proteus delivers all this and works excellently.

I was impressed with how accurately the feeder controlled stock. The tires are soft with lots of traction to keep the feed consistent, and the springs holding the tires to the material are stout. The feeder easily sets up anywhere you can mount a T-track, like at the top of a router or tablesaw fence. The bandsaw setup uses an attachment that clamps to the tabletop. The feeder can be angled too.

You can buy the Little Proteus in several different stages of completion, each requiring different levels of DIY. These start with a very basic kit; then there’s a complete hardware set and plans (you make the wooden parts). The final kit, the one I tested, includes everything except the motor, a brushless hand drill. Believe it or not, the drill works wonderfully.

—Roland Johnson is a contributing editor.

From Fine Woodworking #287

	(Power) Feed Me! I’ve been using small power feeders on my router tables for close to 20 years, and using them has revolutionized the quality of pretty much everything I do with a table-mounted router.
	Small-Shop Power Feeders Consistent cuts and improved shop safety for as low as $250
	Rollie’s quick answers #1 Quick answers to three quick questions about chipped router bits, bandsaw motor issues, and surface plates

Fine Woodworking Recommended Products

Veritas Micro-Adjust Wheel Marking Gauge

The adjuster runs through the beam from a small knob at the back end right to the cutting wheel, which moves in and out as you turn the knob. This arrangement works well but makes adjustments a two-handed operation, requiring a little more effort.

Buy at Lee Valley

JessEm Mite-R Excel II Miter Gauge

The gauge has a quick and easy method for fitting the guide bar precisely to your tablesaw’s miter slot. This means the gauge can be recalibrated if necessary for continued accuracy. The face of the protractor head can be adjusted square to the table and also square to the guide bar. This ensures accurate cuts, and it, too, can be readjusted if the need arises. The protractor head has stainless-steel knobs and fittings and high-contrast, easy-to-read white numbers and increments.

Buy at Amazon

Ridgid EB4424 Oscillating Spindle/Belt Sander

With five spindles sized from 1/2 in. to 2 in. and a 4 X 24-in. belt, this sander has become a staple in many a shop Fine Woodworking visits.

Buy at Amazon