Shop Tips
Safe way to rip unwieldy workpieces
Just glue small workpieces to a larger board.
It can be dangerous to rip small, unwieldy items on the table saw. I’ve used the following method for ripping veneers and dowels, among other things. Simply glue the workpiece to a larger board that is straight and flat, and run the larger piece against the rip fence.
—MIKE GUNDERSON, Yakima, Wash.
Illustrations by Dan Thornton
From Fine Woodworking issue #303
Fine Woodworking Recommended Products
Rockler Dust Right 650 CFM
While all five of the smaller units will collect chips efficiently when deployed properly, the 3/4-hp Rockler was just a bit more powerful in our suction test.
Shop Fox W1826
The thick, felted bag on this Shop Fox is a plus and a minus. On one hand, it makes the unit much less expensive than collectors with canister filters, and also lighter and easier to hang on the wall. Without a separate plastic bag to catch chips, however, they stay in the felt bag, and the shortish zipper on the bottom makes it tough to shake them out. Otherwise, the W1826 is an excellent value.
JessEm Mite-R Excel II Miter Gauge
The gauge has a quick and easy method for fitting the guide bar precisely to your tablesaw’s miter slot. This means the gauge can be recalibrated if necessary for continued accuracy. The face of the protractor head can be adjusted square to the table and also square to the guide bar. This ensures accurate cuts, and it, too, can be readjusted if the need arises. The protractor head has stainless-steel knobs and fittings and high-contrast, easy-to-read white numbers and increments.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
Log in or create an account to post a comment.
Sign up Log in