My fingers don’t have the strength they used to, and I sometimes struggle to open glue bottles after they sit for a few days. This little cap puller is the answer. I drilled a 5⁄8-in. hole in a piece of thin plywood and made a couple of bandsaw cuts to fashion this simple device. It slips under the cap and gives me all the leverage I need. I stuck a magnet in the back to hang it where I store glue.
—Sean Montague, Raleigh, N.C.
—Drawings by Dan Thornton
Fine Woodworking Recommended Products
Double Sided Tape
A thin woven core makes XFasten tape strong yet not too thick (0.008 in.), and helps it hold powerfully without being difficult to peel off.
Rockler Deluxe Panel Clamp
These clamps can handle glue-ups between 10 in. and 36 in. wide, and boards up to 3 in. thick. Sliding feet attach to the lower bars with magnets, letting you position them quickly for stability on any surface. The spring-loaded jaws adjust easily, dropping into notches along the bars. And the powerful clamp handles clear the benchtop.
Titebond I
Perfect glue for almost every type of glue up. Sets quickly so you can keep working.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
Comments
Try substituting a flip up cap from a honey jar
Don't have the time or inclination to make one of these, a 9/16th or 15mm open end wrench is a perfect fit to do this job.
Being lazy or finding a different cap does not make this simple project useless. I am in the process of making a glue caddy, and this will be a perfect accessory to it. Always right there when you need it. Great idea!
Log in or create an account to post a comment.
Sign up Log in