QUESTION:

After reading Roland Johnson’s articles on riving knives (“Who’s Got the Best Riving Knife?” FWW #202) and thin-kerf blades (“Thin-Kerf Blades Are for Everyone,” FWW #204), I’m sold on both products. But will I need a special riving knife for the thin-kerf blades?

Len Jankis, Norman, OK

ANSWER:

Yes. The riving knife should be as thin as or thinner than the kerf of the blade you plan to use. If it’s thicker than the blade’s kerf, then boards will get jammed on the knife, creating a dangerous situation.

The good news is that most tablesaws equipped with riving knives offer a thin-kerf knife as either standard equipment or as an accessory.

Photo: Staff; Drawing: Kelly J. Dunton

Fine Woodworking Recommended Products

Starrett 12-in. combination square

This accurate, robust, well-machined, easy-to-read combo square is as great as ever.

Buy at Amazon

Grizzly G0495X Industrial Helical Cutterhead 8-in. Jointer

Regardless of the board’s grain, this jointer produced excellent results. Its fence was totally flat, worked smoothly, and locked well, staying in place even after jointing multiple edges. Getting the fence to 90° was very easy, but the 90° stop was a little tricky to set and the fence did not go back to square when using it. For those who would use it, there is also a digital depth-of-cut scale.

Buy at Amazon

Shop Fox W1826

The thick, felted bag on this Shop Fox is a plus and a minus. On one hand, it makes the unit much less expensive than collectors with canister filters, and also lighter and easier to hang on the wall. Without a separate plastic bag to catch chips, however, they stay in the felt bag, and the shortish zipper on the bottom makes it tough to shake them out. Otherwise, the W1826 is an excellent value.

Buy at Amazon