Synopsis: Brian T. Derber and his students evaluate a variety of benchstones to see how they measure up to Derber’s experience sharpening on razor hones. They looked at five types and explain why each is best for a particular type of job. Arkansas benchstones are good for high-carbon steel; Japanese waterstones can sharpen the hardest steels. Norton waterstones are an improvement over Japanese in some ways; ceramic stones are narrow but cut well; and diamond lapping plates are best for initial honing. A chart shows how the benchstones compare, listing their uses, pros, cons, and cost. A side article discusses how to know when your tool is sharp enough.

From Fine Woodworking #127

For the full article, download the PDF below:

Fine Woodworking Recommended Products

Marking knife: Hock Double-Bevel Violin Knife, 3/4 in.

This heavy, double-beveled knife stays on track in all directions, and works just fine without adding a handle.

Buy at Lee Valley

Mist Coolant System

A mister for keeping tools cool while you hone them on your grinder. This mister has a base that can be screwed to a support near your grinding wheel or drill press. It conveniently hooks up to a small shop compressor, and by charging it with coolant, you can keep tools rust free.

Buy at Amazon

Suizan Japanese Pull Saw

A versatile saw that can be used for anything from kumiko to dovetails. Mike Pekovich recommends them as a woodworker's first handsaw.

Buy at Amazon