The Thin Air Press opens the door to vacuum veneering for the woodworker who can’t afford the relatively high cost of a conventional compressor-driven vacuum press. This simple system, made by the Roarockit Skateboard Co., uses a vinyl bag with a one-way valve and a hand pump to draw a vacuum.  I used the press to veneer both flat and curved parts and was impressed with its simplicity and performance. I tried both the 13 1/2-in. by 47-in. and the optional 26-in. by 28-in. bags.  The company claims that the pump will pull about 15 psi. I found that the vacuum held overnight, more than enough time for most glues to set.  For more information, visit the manufacturer’s Web site: www.roarockit.com.

—Anatole Burkin is the editor.

Fine Woodworking Recommended Products

Veritas Standard Wheel Marking Gauge

A wheel-type gauge is the easiest to use, and this wonderful Veritas model is a steal at $38.

Buy at Lee Valley

Veritas Micro-Adjust Wheel Marking Gauge

The adjuster runs through the beam from a small knob at the back end right to the cutting wheel, which moves in and out as you turn the knob. This arrangement works well but makes adjustments a two-handed operation, requiring a little more effort.

Buy at Lee Valley

Bessey EKH Trigger Clamps

Bessey EKH series quick-release trigger-style clamps are simple to use and maintain consistent pressure. Trigger clamps that perform the way you've always wished they would!

Buy at Amazon