Machinery - Page 74 of 106

Drill-Press Mortising
October 25, 2005

Inspired by Ken Picou's loose-tenon joinery and Ross Day's shop-built mortiser (Fine Woodworking #98, p. 46), I turned my drill press into a mortiser by adapting a cross-slide vise. I…
Improvements for a Drill-Press Auxiliary Table
October 25, 2005

I was glad to see David Harvey's idea for an auxiliary drill-press table (Fine Woodworking #101, p. 12) because I had recently purchased a floor-standing drill press. However, when I…
Ripping Crooked Stock on the Bandsaw
October 25, 2005

Here is a cheap, easy way to straighten a rough-edged or crooked board on the bandsaw. Screw a length of aluminum or steel-bar stock to the bottom of the board.…
Two Jigs for the Drill Press
October 25, 2005

Cut mortises and angled holes with these easy-to-make jigs
What to Look For in a Planer
October 25, 2005

For small shops, these machines offer good value and performance, but consider features before you buy
Squaring Up Rough Lumber
October 25, 2005

Learn the four-square technique for milling lumber
Jointer Knife-Setting Jig
October 25, 2005

Make this jig to set jointer knives with little fuss
Set the Tension on Your Bandsaw
October 25, 2005

A shopmade jig will help you set the tension on the bandsaw blade.
A Jig for Tuning Your Tablesaw
October 25, 2005

This mounting block for a dial indicator helps ensure an accurate setup
Mastering Table Saw Basics
October 25, 2005

These techniques for ripping and crosscutting will aid woodworkers of every skill level.

Page 74 of 106 Previous

1
72
73
74
75
76
106

Next

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.