Woodworking Jigs - Page 41 of 94

Square Holes for Square Pegs
May 30, 2007

Rough cut the mortise with a hollow-mortise chisel for clean results
Keep Rare-Earth Magnets in Place
May 30, 2007

Rare-earth magnets are great for holding frequently used accessories near my power tools. For instance, I attach an Allen wrench to the frame of my bandsaw with one of these…
Bench Hook Holds Sharpening Stones
May 15, 2007

Sharpen chisels and plane irons at your workbench with this time-saving workbench accessory
Jig for Side-Hung Drawers
May 1, 2007

Simple router table setup makes wooden drawer slides easy
Self-Centering Mortising Jig
May 1, 2007

This simple design makes on-the-mark mortises every time.
Multiuse Measuring Block
April 5, 2007

I often reach for this handy little shopmade measuring tool. It started as a single-use guide for marking holes 3/4 in. from the edge of a panel. Since then it…
Rolling Lift for the Table Saw
April 5, 2007

I often have to move my tablesaw around. So I made a rolling lift that raises the saw onto casters. My design has a couple of advantages over the typical…
Using a Carbide Paint Scraper as a Scraper Plane
April 5, 2007

I recently edge-glued some hard, highly figured Georgia cherry for an armoire. Typically, on a project like this, I’d scrape the wood surface smooth with a card scraper. But the…
Using the Self-Centering Mortise Jig
April 4, 2007

Shop-built router jig is a smart solution to cutting mortises for floating mortise-and-tenon joinery
Essential Push Sticks
March 13, 2007

Safety aids for the tablesaw and router keep your fingers away from moving bits and blades

Page 41 of 94 Previous

1
39
40
41
42
43
94

Next

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.