2 flute straight router bit with a 4″ cut length?

JennAdams | Posted in General Discussion on June 7, 2011 03:16am

Hi All,

Does anyone know where you can purchase this? Magnate used to sell them but it is discontinued, I use these bits for 3″ thick tabletops that have been cut to rough size, and need to trim them flush and square.

Thanks.

Replies

caryhson1 | Jun 08, 2011 07:30am | #1
Wow, that’s big for a hand held router. Why not just use a top bearing bit to get you half way (template on the top) and then a bottom bearing bit from the underside to make it flush with the first cut? 2 bits and 2 cuts, but less likely to have it run on you or snap a bit. Routerbitworld.com sells double and triple fluted carbide bits.
jvk | Jun 08, 2011 10:14am | #2
agree w/ above

I agree w/ the guy above
Troy | Jun 12, 2011 08:51pm | #3
Try Wisconsin Knife works, I believe they make a bit like this, I do like the other suggestions though, thats an awfluly long bit.

Good luck
JennAdams | Jun 17, 2011 10:59am | #4
Thanks

Thank you all for your helpful replies!