Replies

1. 
   peter28 | Jul 18, 2007 05:28am | #1

   Thomas00,

   I'm sorry it's taken a while to get back to you. please be patient and I will answer you on the 23rd.

   I've been getting ready for a big conference and have been preoccupied

   Thanks

   Peter

2. 
   peter28 | Jul 24, 2007 05:37am | #2

   Thomas,

   Here's whats worked for me;

   Using a good sharp pair of scissors and accurate measurements, you can cut the velvet to size. Use a piece of marking chalk like a tailor would to lay out the line on the back of the velvet. It takes a steady hand to cut it accurately. Be sure you don't pull or stretch it as you go or the measurement will be off.

   I'll warm up some hide glue and thin it just a touch with water. Put a thin, even coat of glue on the box bottom. Holding the velvet from each end so you have a shallow U lay the velvet down into the center and lay out the sides. Lightly work any air pockets out from the center and firm it down to the surface.

   You can still move it around a little to square it up. If there is any over lap on the edges, wait until the glue cures and you can lay a straight edge against the side and cut any excess with a sharp straight razor.

   Be careful with the razor so you don't "pull" the velvet.

    You can also lay a small book that fits nicely in the box while the glue sets.

   I've never used velveteen. It's essentially a powdered product that requires almost a dusting to use.

   Good luck

   Peter