I have incorporated my router into the tableboard of my Unisaw.I was wanting to build a router fence that I could possibly use in conjunction with my Biesmeyer Fence.
I am thinking about building something that would slip over my Biesmeyer fence.
Any ideas?
Replies
I made a fence like you are interested in. I made it with 3/4 shop birch ply, slightly shorter than my jet fence and capped both ends of the tube. I drilled a hole in one end for my shopvac to pull the chips into the tube to the vac. Toggle clamps on the back side keep the fence from sliding up and down the fence. Later I added the t-track to attach featherboards. The drawing does not show them, but I dadoed each joint for added strength.
Dr. Bill
I like it. I'll get started on it today!
You don't by chance have an actual picture that you can send me?
Thank you
Mav
Mavrick,
Sorry, no pics. I tried to talk SWMBO into a digital camera for V-day, but it was not "Romantic" enough...go figure. ;)
Dr. Bill
Ok Dr. Bill couple of questions for you.
How tall did you make your fence and the location of your T-Track?
Mav
This forum post is now archived. Commenting has been disabled