Hi guys. I could really do with help troubleshooting a lazzari panel saw.
The blade was bogging down when I was cutting so I got the motor rewind and still same problem. I tried a bigger motor and still bogging down. The single phase saw has the right electrical feed and the blade is spining freely. I just can’t figure it out. Can anyone help? I’m all out of ideas
Discussion Forum
Get It All!
UNLIMITED Membership is like taking a master class in woodworking for less than $10 a month.
Start Your Free TrialCategories
Discussion Forum
Digital Plans Library
Member exclusive! – Plans for everyone – from beginners to experts – right at your fingertips.
Highlights
-
Shape Your Skills
when you sign up for our emails
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply. -
Shop Talk Live Podcast
-
Our favorite articles and videos
-
E-Learning Courses from Fine Woodworking
-
-
Replies
Sorted. Found a small screw to tighten the belt. I'm a idiot.
Does the blade spin freely without power (worn bearing?)
Is the blade clean, sharp and flat?
Is the blade perfectly parallel to the direction of travel? (most likely problem)
I don't know this saw so only general hints...
Sounds like a win.
This forum post is now archived. Commenting has been disabled