Replies

1. 
   john_c2 | Dec 30, 2020 07:47pm | #1

   Stew Mac was always my source.

1. 
   richeytgr | Dec 31, 2020 12:17pm | #3

   Thanks John, I’ll check it out.

2. 
   djcook50 | Dec 30, 2020 08:51pm | #2

   I’ve had good luck with these:
   https://www.leevalley.com/en-us/shop/tools/power-tool-accessories/router-bits/73726-mini-downcut-spiral-bits

1. 
   richeytgr | Dec 31, 2020 12:17pm | #4

   DJ. Good tip!

1. 
   djcook50 | Dec 31, 2020 02:32pm | #5

   Those are nice bits. I've used them with both Dremel tool and the Shaper Origin with 1/8" collet. I'm careful not to go too deep on the plunge; so far, so good.

   DJ

3. 
   mikaol | Dec 31, 2020 08:30pm | #6

   MLCS Woodworking