I got a used Unisaw and a new/used Biesmeyer commerical fence (not installed). I thought I had found and printed the installation instructions but apparently only part of the instructions printed. Now after an hour or so of looking I can’t find them. Anyone have that bookmarked?
xpayroll
Replies
Click on the "Owner's Manual" link on the Support page at the Delta/PC site:
http://www.deltaportercable.com/ServiceAndSupport/ServiceAndSupport.aspx
Wasn't sure if you were concerned about the Unisaw or the fence. As to the Bies fence, it should bolt right to your old Unisaw. I have an early 70s Unisaw and my Biesemeyer fence bolted up just fine. The thread count was different so I used the old Unisaw bolts.
Regards,
Bob @ Kidderville Acres
A Woodworkers mind should be the sharpest tool in the shop!
This forum post is now archived. Commenting has been disabled