Replies

1. 
   John_D | Apr 21, 2006 09:09pm | #1

   I have a G0490.  Had two problems in general:  The belt cover at the back isn't the right size if you have a link belt... and the stock belt doesn't install correctly, because it puts the motor in a position where it can't be correctly secured.

   I've run a number of boards through it, and it puts 'em flat.  I've got the fence adjusted to square, and it puts the boards' edges at 90° too.  That's all I want a jointer for, and it does it. :)

   As to flatness of beds, it's pretty good within the limits of my ability to check it.  I've only got a 24" straightedge though so I wouldn't detect some conditions on these pretty long beds.

   I chose the 0490 because the price was about the same (once you figure in shipping charge differences, and saving $$ on a mobile base), but I liked the extra power, and the longer and 1" taller fence.

   My goal is for my work to outlast me.  Expect my joinery to get simpler as time goes by.
1. 
   user-137989 | Apr 22, 2006 10:12am | #2

   Thanks John. I'm leaning toward the 490. I appreciate the input.