Replies

1. 
   KiddervilleAcres | Aug 23, 2009 04:36am | #1

   Is it the one where he had a TS blade specially ground at 22 ½° ?  If so it's Issue #96 and the article starts on page 66.

   Regards,

   Bob @ Kidderville Acres

   A Woodworkers mind should be the sharpest tool in the shop!

   
   

   ---

   Edited 8/22/2009 9:39 pm ET by KiddervilleAcres

1. 
   marktheshark | Aug 23, 2009 06:17pm | #2

   Thanks but no, not the one.  In this one, he used an adjustable tablesaw jig with a series of wooden spacer blocks to space out the cuts, and for the pins he angled the miter gauge with those same wooden blocks.  I already did it, made the jig, had it come out successfully, and patted myself on the back.  But I lost the article and now all I can do is scratch my head because the devil is in the details, and I'm getting into an increasing number of senior moments.

2. 
   pcott | Aug 23, 2009 07:56pm | #3

   https://www.finewoodworking.com/Workshop/WorkshopPDF.aspx?id=2264
   From Fine Woodworking #96

   Is this the one?

1. 
   QCInspector | Aug 24, 2009 12:07pm | #4

   He also put it in his book "Mastering Woodworking Machines (Taunton Press).

2. 
   marktheshark | Aug 24, 2009 11:49pm | #5

   Absolutely!  Thanks so much.

3. 
   WillGeorge | Aug 26, 2009 01:29pm | #6

   A start?

   http://www.youtube.com/watch?v=N2j4uyzOVlk

   I wonder.. Some cut the slice on the side next to the fence and others do it away from the fence, Which is better?

   
   

   ---

   Edited 8/26/2009 6:35 am by WillGeorge

1. 
   marktheshark | Aug 26, 2009 07:18pm | #7

   I guess you posted the wrong youtube # - doesn't seem to be related the the thread.

1. 
   WillGeorge | Aug 27, 2009 12:36am | #8

   Yep I'm old and sort of brain dead! Sorry!

2. 
   KiddervilleAcres | Aug 27, 2009 04:40am | #9

   Will,

   I got the right article just another technique.  I should think using a special ground blade with Mark Duginske's jig/technique would work quite well.  That way the teeth of the TS cut clean angled corners on the tails.

   Regards,Bob @ Kidderville Acres

   A Woodworkers mind should be the sharpest tool in the shop!