What is the best way to attach the top to the back and vertical members? Stopped dadoes? I’m trying to avoid using screws or nails so I’ll be building this slightly different than the picture shows. Your input is appreciated…
Discussion Forum
Get It All!
UNLIMITED Membership is like taking a master class in woodworking for less than $10 a month.
Start Your Free TrialCategories
Discussion Forum
Digital Plans Library
Member exclusive! – Plans for everyone – from beginners to experts – right at your fingertips.
Highlights
-
Shape Your Skills
when you sign up for our emails
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply. -
Shop Talk Live Podcast -
Our favorite articles and videos -
E-Learning Courses from Fine Woodworking
-
-
Replies
I built some similiar a few years ago. I used stopped sliding DTs except the center divider had egg crate joint. I'm sure the back was 1/2" glued/screwed and the hooks were different as they hung from the bottom shelf. I think the lower molding was 1/2" clamshell.
Good luck,
Joe
Tons of options. Stopped dado, sliding DT, biscuits, loose tenons, etc.
Based on the setup time and joint strength, I'd go with loose tenon joinery for the case. For the back, I'd rabbet the top and sides of the case.
This forum post is now archived. Commenting has been disabled