Replies

1. 
   bakesale1 | Jan 19, 2006 10:11am | #1

   I have one and beliv Nikkiwood(sp) has one too.

2. 
   JJB | Jan 21, 2006 09:47am | #2

   Yes, I think it's a 510 model but not sure. Have run a ton of rough cut lumber of all kinds thru it. It's slow but smooth cutting.
   Right now the motor is in the shop. It seems the starting circuit is bad. New starter switch on top of the motor is & $378 just for the switch that sets on top of the motor. Talk about sticker shock. The shop is trying to find another source. Just letting you know. The overseas motor can rock you. THEN you have the belt drives to worry about. Where will you get those? It's been aa good jointer/planer over the years I think I bought it in 1984, So can't cry too much.
   Take care JJB
   I should say where can I get the flat belts for it, if I get the motor fixed?

   
   

   ---

   Edited 1/21/2006 1:50 am ET by JJB

3. 
   nikkiwood | Jan 21, 2006 09:52am | #3

   I do own one -- the 570.

   I assume you know Inca is no longer sold in this country. But you can still get blades and belts for the above from Garrett Wade.

   What's your question?

   ********************************************************
   "It is what we learn after we think we know it all, that counts."

   John Wooden 1910-