SOLD – INCA Model 250 complete with blades, accessories, detailed owners manual & other documentation. Includes an assortment of high quality Freud carbide blades, machined to the correct 20mm diameter to fit the arbor – 10 inch Freud LU85M 50t combination, Freud LM72t rip, INCA 44t all steel (just sharpened), 8 inch 40t carbide alternate top bevel, 7 1/4 inch rip-frame, 10 inch 80t taper ground steel, and a carbide dado blade. Also includes a very powerful US made Baldor industrial motor that runs on 230V (19 amps) or 115V (28 amps) – currently set up on 230V, but it’s a simple change-over to 115V. Has 20 foot cord. Also long and short aluminum rails, mitre guide with extension & length stop, rip guide, a very nice INCA tenon jig, & mobile base with lock. Has box of wrenches & other small accessories & all the original safety guards – not shown in photos. I am the original owner & purchased it from a dealer in Lexington, KY. This is an extremely accurate cabinetmaker’s saw.
Replies
The Inca 259 is a very nice small saw, I have one. There is an active group of Inca owners on:
https://groups.yahoo.com/neo/groups/incawoodworking/info
If I were to sell or buy Inca tools, that is probably the best bet.
OK, thanks. Very Kind of you.
Guys, I have this saw listed on the Yahoo Inca group - link in John's message above.
Also, I found the original invoice from Garrett Wade listing my saw as a Model 250, so I edited this.
Thanks again, John.
This saw is on my dream list. Good luck selling it. I wish I could buy it!
“[Deleted]”
Saw is SOLD
This forum post is now archived. Commenting has been disabled