Does anyone know why the sides of the issue 188 hanging tool cabinet is 13 1/4 inches wide instead of 13 or 13 1/2? The article does not explain the purpose for this dimension.
It seems that you would want the sides to be a multiple of the 1/2 inch box joint fingers. At 13 1/4 inches you will wind up with a 1/4 finger.
Any ideas?
Steve Pippins
Replies
Is the quarter inch for the piece of plywood that is attached to the back to park two handsaws in?
Regards,
Ken
"Do as you would be done by." C.S. Lewis
Ken, Matt Berger from FWW sent me a response on another post.
Please see http://forums.taunton.com/fw-knots/messages?msg=34171.1.
Steve Pippins
This forum post is now archived. Commenting has been disabled