Replies

1. 
   PlaneWood | Jul 21, 2005 05:20pm | #1

   Run one side through the Jointer till that side is flat, then run the other side through the Planer.

   PlaneWood by Mike_in_Katy (maker of fine sawdust!)
   PlaneWood

2. 
   hammer1 | Jul 21, 2005 06:22pm | #2

   There are numerous discussions on milling sequences, here are a couple of recent ones.

   http://forums.taunton.com/tp-knots/messages?msg=24190.1
   http://forums.taunton.com/tp-knots/messages?msg=24018.1

   Beat it to fit / Paint it to match
1. 
   clint1 | Jul 21, 2005 06:25pm | #3

   Thanks hammer!