Replies

1. 
   BruceS | Oct 28, 2010 04:44pm | #1

   locked up on lock
   Probably the most set-up sensitive bit to use. Use the lower left picture as a guide. The pieces must go together perfectly flush as you would want a glue joint.

   http://eacmedia.net/manuals/shared/021.pdf

   If you care to take the time. You can cut a shim for the outfeed side when running the vertical passes. It's better than running on the "knife edge" Using double sided tape to hold the shim ledge in place.

1. 
   dan nelson | Oct 29, 2010 08:45am | #2

   lock miter

   thanks for your timely responce and pdf it helps greatly. dan nelson