Alan,
I have just purchased my new workshop which is a 20′ x 20′ building. Realizing that my shop tools have different sizes. I was wondering if you would give me the sizes of your drawers and cabinets. Of all shop set-up I have looked at yours is a total thumbs up. I really like this set-up. Thank You!
Replies
Thanks for the kind words.
Following are approximate dimensions:
Router table cabinet: 16" x 29" door (for router access), 4 drawer stack 23" wide x 29" high. 29" deep.
RAS cabinet: two 3 drawer stacks, total width 57" x 23" high, 29" deep. I built a 3.5" thick x 40" x29" torsion box (top of cabinet) to support the RAS, it has a 3.5" x 40" MDF fixed trim strip across the front.
Planer station: two 4 drawer stacks facing outward (opposite directions), 22" wide x29" high x 20" deep. Two 3 drawer stacks side by side under the planer, total width 29" x 29" high x 22" deep.
Cabinet under dust collector: Total width 48", depth 29" height 30". The chip cabinet door is 16" wide. The two doors accessing the shelves to the right of the dust cab are also 16" each.
Table saw outfeed: Shelving unit 67" wide x 29" deep x 30" high. Three equal width doors.
The band saw is mounted on a shelf bridging between the DC cab and the TS outfeed cab, door to this space is 17" x 30".
Hope this helps, and good luck with your new shop.
Alan
Thanks Alan! I am really looking forward to building this Island.. My sons and I sheetrocked the walls today. Will be doing the ceiling next week. Again thank you for sharing your island to us. Terry Rielly
This forum post is now archived. Commenting has been disabled