Hello, I am trying to miter a 1X10 to a previously installed 1X10 and the miter is a little off, so I need to cut a 55 degree edge, however the board is 8 ft. long and I cannot put it through my saw perpindicular because it would hit the ceiling and the whole starts to seem pretty precarious. Any suggestions for a jig, etc. when cutting long pieces more than 45 degrees??
Discussion Forum
Get It All!
UNLIMITED Membership is like taking a master class in woodworking for less than $10 a month.
Start Your Free TrialCategories
Discussion Forum
Digital Plans Library
Member exclusive! – Plans for everyone – from beginners to experts – right at your fingertips.
Highlights
-
Shape Your Skills
when you sign up for our emails
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply. -
Shop Talk Live Podcast -
Our favorite articles and videos -
E-Learning Courses from Fine Woodworking
-
-
Replies
Check out this tip from issue #118. It might do the trick. Let me know if you need to take another approach and I'll look around.
http://www.taunton.com/finewoodworking/subscription/Workshop/WorkshopArticle.aspx?id=3399
(Note: the degree sign shows up as an "i" for some strange reason)
Matt Berger
Fine Woodworking
This forum post is now archived. Commenting has been disabled