Dear sirs
My name is Thomas Echols and I was looking at the miter
sled for the table saw. the only problem i have with it is I
have a Skill ten inch contractors table saw and it has the
grooves in thr slide bar for the miter guage and just how can
I fix the sled to where it will fit because there are two sets of
ears on each slide track so that the miter guage can fit in. I
would appericiate all the help you can give me in this matter I
do a lot of picture frames and shadow boxes and this would help
greatly thanks for your time may God Richly bless you all.
Thomas Echols
Replies
I have a Bosch table saw and it also has a T track for the miter bar.
You can make runners that fit the main portion of the track and ignore the t section!
Chaim
Howdy Chaim
I thank you for the information will give a try will get back to you
on how it does. Thomas echols bigwoods
This forum post is now archived. Commenting has been disabled