Hello,
I’ve lurked here for some time but I don’t think that I have posted before. I apologise if this is the wrong forum, but none of the others seemed to fit my question.
I bought a Record 53 vise at an auction a while back and it seems to have a part missing at the back end of the screw thread. I have, hopefully, attached a couple of pictures. I would be really grateful if someone would direct me to a parts diagram, or post a picture of the back end of a similar vise.
Thanks.
Replies
I always wanted to be REALLY helpful
Not exactly the same vise but she's a Record
Perfect ! That's just what I needed. I was missing the washer behind the pin. Thanks a lot !
Diagram
See The Workbench Book by Scott Landis page 143
Shows a #52 1/2 D
The rear plate is pearced like mine for the two guide rods.
Shows two washers both on the rear most side of the plate and a pin that presses through the hole in the large main screw.
This forum post is now archived. Commenting has been disabled