Hi all,
Has anybody tried fitting an aftermarket rip fence on this saw? The rip fence that comes with the saw is pretty lame. I like the looks of the fence for the 18″ Jet, but I don’t think it would work since the MiniMax blade goes through the front of the table where the Jet fence attaches…
I currently use a homemade fence for resawing that works ok. It would be nice to have a “real” fence that could extend past the left edge of the table for ripping wider stock.
Replies
Not sure of the model # and you didn't give enough information to clue me in but is that the four foot slider? There was a special biesemeyer that was sold with it. The fence was offset to the right, unlike the traditional biesemeyer which is centered on the "T". There is a minimax owners group at yahoo
http://groups.yahoo.com/group/MiniMax-USA/
This is for the S45 bandsaw. Sorry if that wasn't made clear.
Who can remember all the numbers! It's always better to have more info than less.
Edited 10/22/2003 3:08:07 PM ET by Rick at Arch. Timber and Millwork
This forum post is now archived. Commenting has been disabled