Replies

1. 
   Routerman | May 04, 2011 12:06am | #1

   I'm assuming all router table processing. Unless you have plenty of priors and an escape option; I would not trap the work between the cutter & the fence. There is fixturing and technique that will allow safe work travel for sizing. But don't try it cold x guess & x golly.

   http://www.patwarner.com = Routin'

2. 
   BruceS | May 08, 2011 04:15pm | #2

   Trapping lumber

   Something I would avoid at all costs.

3. 
   AutumnWoods | May 08, 2011 05:41pm | #3

   Only if you want to die :-)

   Or your trying to create a router powered rail gun with a wooden projectile.  :-)  If you're milling properly your pieces should be a consistent width anyway.  If you don't have the tools to mill properly, your boards are probably not going to be straight enough from the start to perform the kind of operation you're talking about without binding and throwing the piece.