Replies

1. 
   [email protected] | Mar 01, 2007 10:29pm | #1

   I'm not getting a good mental image of what you are trying to ask. 

1. 
   Toolguy | Mar 02, 2007 12:17am | #3

   I would like to use a miter gauge at times, so the dado to be cut sould be what distance from the router bit center for bust results

   Thanks

1. 
   ajoe | Mar 02, 2007 12:29am | #4

   Just far enough for your miter (when set at 90 degrees) to clear you widest bit. Mine is at 5 inches (center to center).

1. 
   Toolguy | Mar 02, 2007 02:11am | #5

   Thank you for your help I set I will set it at that dimension

2. 
   ajoe | Mar 01, 2007 10:56pm | #2

   As you face the router (fence will be perpendicular to your line of sight), place the hole dead center from left to right and 2/3 of the distance to the rear edge of the table.