Replies

1. 
   oldusty | Apr 11, 2009 05:54pm | #1

     tfb ,

         Not sure I understand but , could you make the dado before the radius ?

         tell us more maybe we can help

                   regards dusty

2. 
   saschafer | Apr 12, 2009 01:56am | #2

   A slot cutter in a router table would do the job. The bearing on the slot cutter that I use most often has about a 7/16" radius, so that would fit into the inside corner without difficulty.

   By the way, when the slot runs along the grain, it's usually called a groove rather than a dado.

   -Steve

1. 
   tenderfootbob | Apr 12, 2009 06:52am | #3

   Thanks Steve. The slot cutter sounds like a very good idea.

   Tenderfootbob