Shop made router table in my tablesaw
![](https://secure.gravatar.com/avatar/742917c34719e54983555f0e603b97d1?s=52&d=https%3A%2F%2Fimages.finewoodworking.com%2Fapp%2Favatars%2F200x200%2Fr.png&r=g)
I have a Delta 10″ Contractors saw w/a Biesemeyer 40″ Home Shop fence. I have built a right extension table to accomodate the Biesemeyer fence upgrade as well as an outfeed table. Because I have a rather small woodshop ( 16′ x 16′), I would like to replace my left extension table so I can incorporate my Hitachi 3 HP plunge router into the tablesaw to conserve space.
I would like to use the Biesemeyer as a fence for the router, by attaching an auxilliary router fence, that I have designed for it. On paper, it appears that it should work quite nicely.
Would anyone have any suggestions as to how I should construct the router tabletop?
Replies
Hi,
I just did the same, I basically cut out a piece of the extension to fit my router plate and I am asking myself now, how come I did not do this 100 years ago. I have the incra fence for the router (twinlinear) and the plate can raise or lower the router (I forgot the name). The setup works real nice. I just need to atache the dust colector, which I don't see a problem
Regards,
manny
Hi Rob. I have a similar setup. Delta con. saw and Hitachi router. I bought a Veritas router table top and fence and I drilled and tapped the top to accept a piano hinge. I then attatched this to the left side of my saw. I swing it up and flip out a leg when I need it and drop it down out of the way when I don't. I also put a adaptor on the end of my router dust collector that brings it up to the saws 4" hose. Just switch the hose and go. It works great.
This forum post is now archived. Commenting has been disabled