Replies

1. 
   John_D | Jun 01, 2006 12:10am | #1

   FYI I looked at the Biesemeyer page, and for Powermatic they have splitters only for the 63 and 66.

   My goal is for my work to outlast me.  Expect my joinery to get simpler as time goes by.
2. 
   Knotscott | Jun 01, 2006 01:52am | #2

   The Microjig splitter will work.

1. 
   John_D | Jun 01, 2006 02:26am | #3

   That's the one that sticks in the insert plate, right?  Ever forget to remove it when doing a miter cut? :)My goal is for my work to outlast me.  Expect my joinery to get simpler as time goes by.

1. 
   Knotscott | Jun 01, 2006 02:00pm | #4

   Yep...that's the one. Actually, I don't own one but thought it should work...it looks low enough that it shouldn't interfere with most cuts. If I had one and it could interfere with miter cuts, I'd definitely forget to take it out sooner or later! ;)

3. 
   RonK | Jun 01, 2006 04:11pm | #5

   I believe that Merlin makes a splitter for the General 185 left tilt contractors table saw

   http://www.excalibur-tools.com/products/merlin.htm?product=merlin

   If my memory serves me correctly the General, Powermatic and Bridgewood contrator saws come from the same Taiwan source. You might try calling Melin and see if the General unit might fit your saw.

    

1. 
   vtuq | Jun 01, 2006 08:06pm | #6

   I looked at the General and it looks like it would fit. I called the Excalibur folks a few months ago and was told that the Merlin would not fit, however the person on the other end of the phone seemed confused. I think try again.

   <!----><!----> <!---->

   Thanks Jim