Rt01 Overview features: 3-28×28 woodpecker tops, Incra TS rails w/ LS positioner & wonder fence (flip flops to rt side) Rt side has interchangable tops & adjustable air intake for DC, L side features rotating top, drawer for bits, Ctr has sliding drawers for storage
RT02 L side toggles hold top in place, crank handles adjust router plate (up & dwn)
Rt03 table insert removed for rotating
Rt04 Table rotates to 150 deg, ctr table slides up against table for material
Rt05 When end routing suction thru insert hole picks up 90% of dust.
Rt06 Auxilary top storage
Rt07 Downdraft top installed
Rt08 Work top installed
Rt09 Spindle sander top
Rt 10,11 sliding dovetail on beveled corner w/ table @ 45 deg
RT 12 mitered corner w/ dovetail w/ table @ 45 deg
trimjim
Replies
Yeee Hah!
That aircraft carrier would take up half my shop!
Is this for production work?
Impressive.
Mike
Awesome. Would you mind posting some pics of under the rotating router end. Ones of how the carrige moves and how the table rotates.
I have most of the Incra stuff but mt setup HARDLY loks like yours!
Great post (Well, for me it was!) Dang! and I never thought of that two router hole ya have! DAH! I loved it!'
THANKS for the post! Mine just attaches to my Ridgid saw (I like the saw. Cheep! and it cuts more than OK. And I make some pretty nice projects if I don't say so myself...
I have the ridgid saw also & my original rotating table was attached to it. That was 4 yrs ago, then I built this one about 2 yrs ago. Thankstrimjim
WOW!
This forum post is now archived. Commenting has been disabled