I’m curious as to what others do for table saw inserts for general purpose dado cutting. I’m not asking about cutting primo dados; I can do that other ways.
Do you have a set of saw inserts of differing widths or do you use one cut at the max width?
thanks
dave
Replies
I use a zero insert for my forest II Blade. Another for cutting 3/8" and less datos, and two plywood inserts for over 3/8 to 5/8 and another for 5/8 to 3/4".
Dave
Our shop typically makes up a stack of 20 or so at a time and use them for different widths.
I just use the factory one made by Delta.
Darkworksite4:
Estamos ganando detrás el estado de Calif. Derrotando a un #### a la vez. DESEA VIVO LA REVOLUCIÓN
This forum post is now archived. Commenting has been disabled