General Discussion Archives - Page 2168 of 2282

Router Table
August 19, 2002

Due to space consideration, I am looking at purchasing a router table which replaces the wing on the table saw. Does anyone have any experience with these units? Any cautions…
Ceramic blades
August 18, 2002

Would ceramic blades be better than metal for woodworking? Kyocera makes knife blades of zirconium oxide, which holds an edge much longer than metal. The higher-end blades (they're all expensive)…
sharpening hand tools
August 18, 2002

I'm trying, and succeding IMO, to teach myself chip and relief carving. Without a doubt the hardest part of this skill to learn is "consistently" putting a good edge on…
Which BS blade for bowl blanks?
August 18, 2002

Lathe turners, I need a suggestion for a bandsaw blade for my Delta 14" BS, suitable for roughing out bowl blanks. I usually use seasoned wood, but sometimes luck onto…
EASTWEST WOODS in ca
August 18, 2002

Has any one had any experience dealing with east west woods in vista ca. It seems the sell reclaimed lumber from the southern california area. Has anyone been over there?…
Sources for Hardwoods in Spokane Area
August 18, 2002

I know this kind of question gets posted frequently. Nevertheless, here goes. I just moved to Coeur d'Alene, Idaho. Who, and where are the good hardwood suppliers in this area…
Bandsaw selection – Laguna 16?
August 18, 2002

I'm settling in on the Laguna 16 or the Minimax s45. Leaning towards the Laguna, despite some bad will on customer service that's out there. My readings seem to indicate…
Who will buy FWW’s 155 issues CD?
August 18, 2002

I think most have seen the ad on Fine Woodworking's homepage about their upcoming CD rom, "The Best of 155 Issues". I, for one, am excited about it, and would…
Rookie Mistakes
August 18, 2002

I know we've got a handful (at least) of newbies out there, 'cause they've been brave and posted introductions. I made a rookie mistake yesterday, thought I'd pass it along…
Rocker layout
August 17, 2002

I am designing a rocking chair and am stumped on how to layout the rocker itself. Also would some opinions on bending or cutting the rocker. Which would be the…

Page 2168 of 2282 Previous

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.

General Discussion Archives - Page 2168 of 2282

Get the latest from Fine Woodworking Magazine

#314-Tools & Shops 2025

#313-NOV/DEC 2024

#312-SEPT/OCT 2024

#311-JULY/AUG 2024

#310-MAY/JUN 2024

We hope you’ve enjoyed your free articles. To keep reading, become a member today.