General Discussion Archives - Page 2244 of 2288

I am considering a Multico dedicated mortiser from Garret Wade.  It is made in England and appears to be more substantial than the Delta or Jet equivalents.  Anybody have any…

Since the windy weather around here (La Plata, MD )I've got unintended logs to harvest. Such as the 20 inch river birch on my drive. It has a pretty brown…

Does anyone know of good, small sawyers who would be willing to provide and custom cut two or three logs? There is virtually no hardwood growing in my region. The…

Hi, Houston, TX here.  Has anyone seen those stools that are made with a "tractor seat?"  I have seen them in some of my travels in the Hill Country of…

I recently bought a stack of 11.5 x 17 cherry raised panels for $1 a piece- no kidding. I was thinking of making wainscotting. I bought some rail and stile…

Friends, No kidding. A fellow I met at an antique shop and I started chatting about repairing some of his "junque". As I was leaving, he told me he has…

Hi Guys, I’m thinking about changing my shop over to square drive screws and am interested in hearing people’s opinions. Actually, my experience is that those people who like them,…

Can anyone offer any tips/experience regarding the use of Trex bender-board ("one by") lumber in glued/bent/laminated outdoor structures?  I'm intending to construct a freeform grape arbor out of the mentioned…

I do quite a bit of routing, I trim houses for a living.  I use a 3hp PC router in a table.  I am concerned about the dust that falls into…

Hi All, I recently picked up a powermatic mortiser. after a few test plunges I noticed the bit was getting really hot.  In a production run of plunges, would anyone…