Hand Tools Archives - Page 95 of 258

BB, If you have questions about items on "the Best Things", just write to the proprietor, Lee Richmond. His email address is: [email protected] If there is a more knowledgeable person…

The Handtool forum is running a little slow  - this may interest some. Below is a link to a review of Andrew Lunn's carcase saw. http://www.inthewoodshop.com/ToolReviews/EccentricToolworksCarcaseSaw.html Regards from Perth Derek

Anyone try or seen both? What are your thoughts? This would be a 1-1/2" blade for a Krenov style plane. Timberwerks Studio Blog  Timberwerks On Twitter    

My brother gave me a Gripmaster [Clarke National] vise set.  It is complete & complex, and without a manual.  and probably made before websites were popular.  I haven't been able…

Has anyone out there gotten their mitts on one of the LN panel saws yet? What's the skinny?  I am thinking of getting one since Mike W doesn't seem to…

Hi Folks, I am a newbie to woodworking but have been doing relief an chip carving for about 10 years. I got it in my head that I would like…

I have an ECE Primus Reform ImprovedsSmoothing plane.  Bought it many years ago, but never used it.  I flattened the bladed and sharpened the edge.  I cuts great, but i…

I'm putting a stopped groove in the top and bottom of some shoji screens..I used a multiplane to make a centered 1/4" groove a 1/4" deep. However, I was unable…

I'm not certain which thread or which person was discussing the dovetail saw sold by Adria recently, but it caught my interest. I checked the website and ended up purchasing…

I scanned the following photo from the dust jacket of The Workbench, by Lon Schleining. As you can see, there are two Veritas hold downs, and two other things that…