Jigs, Fixtures, Tips & Tricks Archives - Page 15 of 69

Is rare earth magnets the ones to use?What is the significance of the N-xx number after the rare earth magnet?Thanks

So I would like to make this jewelry box, but I can't figure out how to cut the curved four sides of this box.  The sides without the top is…

I am thinking about putting two thin kerf 7.25 inch blades on the arbor of my 10 inch TS with a spacer to easily get thin strips.  I will consider…

Is the key word when looking for powerful magnets for jigs and holddowns "rare earth" magnets?I have seen magnetic holddowns to cast iron surfaces that is quite strong. Thanks

I sense that T-tracks are used indiscriminately. T-tracks are needed generally only where continuous attachment is needed, such as stops.For clamping, a cheaper and strong mechanism is usually available.  Here,…

So, I am getting ready to start building a crokinole game board out of some boards I have on hand.  The boards are old maple flooring.  For this project, I…

For an up coming project, I need to cut some very accurate tapers. To the tune of essentially making a 64 sides polygon. For this I am considering using 2…

I watched a video here where Steve Latta modified a stewmac dremel base to allow it to cut cirles and arcs but can't find any articles or plans on how…

https://youtu.be/Dzh09IH5fvI

https://youtu.be/qxP-d_Zi0vk