Jigs, Fixtures, Tips & Tricks Archives - Page 34 of 69

     Every now and then I make some wonderful mistakes , today I was routing a small bullnose up the finished ends of a pair of bookcases , I meant…

I'm about to do several cabinet doors for my son's kitchen and its the first time I've used rail and stile router combo bit set. My main concern is the…

Does anyone know of a jig or tool for helping get large panels tipped up on the table saw. My shoulders are not what they used to be . Rotating…

I'm taking over production of some woodworking pieces that we previously purchased from Sweden.  I'm not not certain how produce the pieces most efficiently.  Any suggestions would be helpful.  We make hanging…

There's an article on the FW database that I had and now can't find.  By Mark Duginske on cutting dovetails on the tablesaw (and bandsaw).  Anyone can direct me to…

I have a need to cut a very precise sharp angle for a flag presentation box and would like some ideas on which tenon jig to buy. I thought of…

I have seen folks taper legs on the jointer by taking the total amount of taper, dividing it by two and then setting the depth of cut on the jointer…

I'm visiting from BREAKTIME, although right now 20% of my business these days is furniture....so I guess I have a right to post here?? I built some cabinets in my…

I have a 25 yr old Elu Dovetailer which has not seen very much use - maybe a dozen drawers in total. The bit however has not fared too well…

Hey guys, Trim routers are great tools, but the base is so narrow that they have the tendancy to tip over when milling edges. While one hand holds the router…