Jigs, Fixtures, Tips & Tricks Archives - Page 66 of 69

Hey guys, How do I find the radius of an arch if I have these measurements? Check out the picture. thanx, Lou

Hi I am new to wood working and could use a little help. I just finished reading a article called A Better Tapering Jig by Richard W. Beebe II. My…

  Hi    I have a Jenn-air exhaust fan and am building a shop air cleaner.  Have any  FWW readers built  similar equipment  or are there any articles in past…

I'm trying to find a jig that I can make that uses my router to create decorative bedposts rather than buying a lathe. Does anyone know where I can find an…

Can anyone recommend an online source for electrical parts and switches? I've been using Reid Tool for jigs and fixture components, but their selection of electric parts is pretty limited. Specifically…

I recently read Fine Woodworking's "Designing and Building Cabinets," and ran across a reference made by writer, John Green, regarding an "overhead router made from scraps of plywood." If anyone…

I recently built three mahogany tilt top tables from an article in FWW by Mario Rodriguez. I had a little trouble cutting the sliding dovetails in the table legs. I…

Hi all, I have recently bought a second hand 12" portable planer. The problem with this old model is that it does not come with a dust/chip extraction hood to…

I'm starting a chest that has onion bun feet legs to be turned on the lathe and I'm wondering if it would be ok to use walnut?  The plans call…

Just Curious, Regarding Shop Safety,   On my table saw I use a various assortment of board buddies, feather boards, magnetic feather boards, a splitter and at times vertical feather boards. I…