Jigs, Fixtures, Tips & Tricks Archives - Page 7 of 69

On page 30 of print issue 295 there’s reference to a downloadable PDF of dovetail template used by Chris Gochnour for his contemporary end table. Nice work by the way.…

Does anyone know if there is an article or plans to build the drawer set into the Grizzly G0529 Spindle Sander Cabinet Base?

I have a project that requires 2"x2" trim. I have been searching for information on how to route a 2x2 piece of wood, but I am having a hard time…

Hi all,I am an amateur woodworking enthusiast learning as I go and when I have free time. I am somewhat frustrated with my experiences using a shooting board. I have built…

I got a Router table to diversify my uses of my router, and I’m looking for advice on ways to use the T-tracks in the table surface. What kinds of…

Hi,I glued square pieces of end grain of spruce tips to make a top of dining table. My table is not finish but this summer, the table curved in both…

I have reviewed this post https://www.finewoodworking.com/forum/porter-cable-dovetail-jig-problem and still struggle with my half blind dovetails being way too tight.I come from a hand tool background and can cut half blind dovetails with a…

Hi, not necessarily a woodworking problem but I am struggling to find a jig/fixtures to hold my workpiece in place whilst also stop it from moving downwards when drilled into.…

I came up with this I'm sure I'm not the inventor, but it has made producing the frames very easy and very accurate.

Dear fellow woodworkersI have a new woodworking project coming up that requires both angled tenons and mortises to fit into each other.  I have searched Fine Woodworking and the web…