John White Archives - Page 53 of 81

Hi John, Where can I find a list/chart with proper bandsaw tension in psi for various width blades? Will this vary between manufacturers? Thanks, Dan

John, Recently I read that one of the advantages that High Speed Steel has over high carbon steel is that it does not need to be heat tempered and therefore…

Does anyone know about or have experience with raising/lowering tools using pneumatic or other methods? I have a small shop and would like to store a jointer under a counter…

I have a Rockwell/Delta 1/2" floor model (15-655) that kills my back  when I raise and lower the table. Does anyone know a way to change/alter/add/modify my drill press so…

I have a quick question. Just bought a Biesmeyer 36b-30 fence at lowes. I also just got my grizzly 1023 saw in too. I haven't put the saw together but…

Hello John, you're a hard man to find! your web page is down, (SORRY exeter I'm new to this!!!)                                                               I'm building a four foot long version of your 'New…

Hi, I'm a intermediate wood worker, but a novice equipment owner.  I just purchased two tables saws (long story) and after setting up both, I've been successful with one, and…

I have a full time job and have been woodworking for about a year when I can find the time.  I've purchased tools along the way and I'm on a…

John I recently purchased a bandsaw rated a best buy in Fine Woodworking. I am a novice woodworker, but it seems to me the unit vibrates too much. I called…

This concerns another question about the thrift shop retangular drop-leaf table which has one gate-leg set in the middle to support the 17x41-inch drop-leaf.  Upon further consideration, I realized that someone…