Joinery Archives - Page 33 of 299

Hi, I try to repair a wedged tenon. What kind of wood should be used for the wedge ? should it be softer, harder or as hard as the tenon…

In a recent FWW an article by Steve Latta building the serpentine sideboard and discusses gluing up the door fronts from 1/8" bending plywood.  I understand the need to use a…

I want to create a table top that has a mitred wrap around the edge.  For breadboard ends, allowing for expansion/contraction is understood.  But, in completely wraping a top with…

Although not new to woodworking, I don't possess vast experienced in furniture building and could use some quidance, I am interested in building a piece similar to the attached photo (non-copywrited), however, I.m puzzled by a couple…

Hi there.  I am new to the forum and looking for advice about a slab table I am building. I work at a school and was able to snag two…

Hi -- I'm completing a piece that has 20 or so mortise and tenon joints.  Unfortunately, I messed up a few of them and they are fairly loose, I would…

  I am building a campaign desk for a client and I am not sure how to join the top and bottom to the sides.  A sliding dovetail would not…

I have a large maple slab about 2 1/2" thick I'm going to use for a tabletop. The tapers into a "Y" shape with a 45" long crack through the…

I'm making a cradle from walnut.  The two ends of the cradle have raised panels.  When routing the profile, I created a small crack in one of the panels (I…

I'm a new member to the forum and thought I would give the forum a try... I'm building a 6' round table of bubinga. The top is comprised of 8 pie…